Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
Installing in an old sleeve
1. Remove the rear grille from the sleeve and replace it with the new grille. 2. The part number label on the grille should face the inside of the room. NOTE: If your sleeve is of another make, you can purchase a sleeve and adapter kit designed to adapt your sleeve to this air conditioner. An accessory kit is also available for window installation. Both kits are available from your local dealer.
Installing in a new sleeve
1. Remove the front and back covers. Save these for future use to seal the sleeve if the air conditioner is removed. 2. Remove the rear grille from the sleeve. 3. Brush out all debris from inside the sleeve making sure the inside is clean and that th�e drain holes are completely clear.
4. Loosen screws in the rear grille to about l/s�. Then, while holding on to the wire loop, tip the grille and pass it through the rear opening of the sleeve. The baffle contact area should be on the left.
