jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 395 (kliknij aby zobaczyć)
DV MECHANICAL ADJUSTMENT MANUAL VII
3-25. Coaster (S) Block Assy and Coaster (T) Block Assy
1.
1)
Removal procedure
Remove the coaster (T) block assy 1 from the coaster (T) block shaft. Remove the coaster (T) block assy from the right groove of the drum base. Remove the coaster (S) block assy 2 from the coaster (S) block shaft. Remove the coaster (S) block assy from the left groove of the drum base. Remove coaster (S) assy 3 by rotating it through the key hole of GL (S) assy 4.
2.
1) 2)
Attachment procedure
Install the coaster (S) assy 3 into the key hole of the GL (S) assy 4 by rotating it. Insert the coaster (S) block assy 2 into the coaster (S) block shaft. While aligning it with the left groove of the drum base, push it in the way that the V-groove comes to the top until it reaches the pressure-bearing S. Push in the coaster (T) block assy 1 along with the right groove of the drum base. Align the phase of the GL gear S, GL gear T and the GL drive arm at the three phasing locations. Then install the coaster (T) block assy 1 in the coaster (T) block assy shaft.
2)
3)
3)
Key Points in Re-assembling
� When aligning the coaster (S) assy with the left groove of the drum base, the V-groove must come to the top. � TG4 and TG5 must not have any stain and their arms must not be deformed.
2 Coaster (S) block assy 4 Keyhole of GL (S) assy
Phase Adjustment Key Points in Re-assembling
When re-assembling, adjust the gear phase at the three positions. GL gear (S) GL gear (T)
V-groove must come to the top.
3 Coaster (S) assy
1 Coaster (T) block assy
Coaster (S) shaft
Pressurebearing S V groove The second tooth from the left
GL driving arm Drum base groove GL gear (T) � mark
GL gear (S) GL gear (T) shaft GL driving arm
The second tooth from the left GL driving arm
� The second tooth from the left of the GL gear (S) and the V-groove of the GL gear (T) must be in phase. � The second tooth from the left of the GL drive arm and the v mark must be in phase.