TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think there is something wrong with this component, check the points below. Sometimes the trouble may originate from another component. Thus, also check the other electrical appliances also in use. If the trouble cannot be rectified even after checking the following items, contact your dealer or nearest PIONEER service center. Problem The power does not turn on. There is little or no sound. Possible Cause ÷ The power cord has not been connected. Countermeasure ÷ Connect the cord to a power outlet.
÷ The Input selector switch is in the wrong position. ÷ The rear panel�s PHONO/LINE selector switch is set to [LINE] when a analog turntable is connected to the input connectors. ÷ The connection cable hasn�t been connected properly or has been disconnected. ÷ The terminal or plug is dirty. ÷ The TRANSFORM lever is tripped.
÷ Set the Input selector switch to the device currently playing. ÷ Set the PHONO/LINE selector switch to [PHONO].
÷ Connect it properly. ÷ Clean and reconnect. ÷ Return the TRANSFORM lever to its upright position. ÷ Adjust MASTER LEVEL dial. ÷ Adjust the TRIM dial so that the input level approaches 0 dB on the peak level meter. ÷ Set the PHONO/LINE selector switch to [LINE].
Sound is distorted.
÷ Master output level is too high. ÷ Input level is too high. ÷ The rear panel�s PHONO/LINE selector switch is set to [PHONO] when a cassette deck or other line component is connected to the input connectors.
CD player�s fader won�t start.
÷ The top panel�s FADER START button is set to Off. ÷ The rear panel�s PLAYER CONTROL jack hasn�t been connected. ÷ The top panel�s SEND buttons (MIC SEND, CH-1 SEND, CH-2 SEND) are set to Off.
÷ Set the top panel�s FADER START button to On. ÷ Use the control cord to connect the unit and CD player. ÷ Turn on the top panel�s SEND button corresponding to the channel you wish to apply external effects to (indicator will light). ÷ Connect an external effector�s output coupler to the RETURN jacks. ÷ Lower the external effector�s output level.
External effector don�t work.
÷ An external effector�s output coupler is not connected to the RETURN jacks. External effector�s sound distorted. ÷ The input level from the external effector is too high.
Static electricity or other external interference may cause the unit to malfunction. To restore normal operation, turn the power off and then on again.
