KORG KARMA
Skrócona Instrukcja Obsługi

Karma EasyStart

5.

Press the [MENU] key, then press [F1] to highlight �LOOP� Press [F8] to open the Loop Page Hold down the [TIMBRE/TRACK] key, and press [F2] to select Track 2 Press the [VALUE ] key to check Track 2�s loop box CURSOR and leave the loop start value at measure �001� CURSOR and set the loop end value to the last measure that you played on Track 2. Repeat steps 4 and 5 as desired Complete your new hit song Go on American Idol and win dollars Move to the Virgin Islands, buy a generator and play with your Karma on the beach. Make millions of

6.

New! Alternate quick song method featuring One-Touch Recording:
1. 2. 3.

Choose any Program or a Combi Tweak the KARMA REALTIME CONTROLS as desired [TIMBRE/TRACK] key at least 3x to enter a desired tempo.

Tap the

Hold down [ENTER] and press [REC/WRITE] Press [F8] to answer �OK� to �Setup to Record: Are you Sure?� KARMA jumps to Record mode, with the [REC/WRITE] key already armed. Press [START/STOP] to begin recording Press [START/STOP] again to stop recording. What could be easier?!

New! Tone Adjust in Sequencer mode:
1. 2. 3.

Press the [MENU] key

Press [F5] until �Tadj�(Tone adjust) is highlighted, then press [F8] to �Open�.

Hold down the [TIMBRE/TRACK] key and choose a Track for tonal shaping by pressing one of the [F1] � [F8] keys. Turn the DIAL or use the [VALUE ]/[VALUE ] keys to choose from the 25 parameters available for adjusting CURSOR to access the �value field� of the chosen parameter Enter the desired value with the [VALUE /VALUE ] keys, the DIAL, or type in the desired value on the numeric keypad and finalize by pressing [ENTER]. Each track may have six of these 25 parameters tweaked at the same time, allowing you to quickly edit a Track�s Program without having to leave Sequencer mode!

!

Automating the Mix
1. 2. 3. 4. 5.

CURSOR to the Track field and select a track from the steps above for mixing. Press the [F6] �Pref.� key and press the [VALUE ] key to select �Over Dub� for �REC setup.� Press the [F4] key to view the Mix for tracks 1-8 While holding down the [TIMBRE/TRACK] key, press the [F1]-[F8] key to highlight the desired Track CURSOR once to highlight the volume �wedge� for this Track. Press the [REC/WRITE] key, then the [START/STOP] key, and record volume changes on the track by turning the DIAL Press [START/STOP] when finished. Press [START/STOP] to audition the results; the volume wedge and value will update as the song plays back that Panning messages may be recorded in similar fashion. Note

5