jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 12 (kliknij aby zobaczyć)
9. MESSAGES
Problem ERR! message appears for one second. Possible Cause � Attempt to input two the same text. marks within Action � Use only one mark. Only two lines of text can be input, so text can contain only one mark. � Do not use marks. 6 mm tape can have only one line of text, so text cannot contain any marks. � Delete the mark to print on 6 mm tape or switch back to a wider tape.
� Attempt to input mark while 6 mm is specified as the tape width.
� Label text containing a mark was input and then tape width specification was changed to 6 mm. (ERR! message appears when you try to perform a print operation.) � Text that is longer than 5.5 cm when stamp printing is selected. � Attempt to print a stamp while 6 mm is specified for the tape width. FUL! message on the display. BATT message on the display. ERR! message on the display. � Both text memory areas (AREA 1 and AREA 2) already contain text. � Battery power is too low. � Memory data has become corrupted for some reason. Table-4
� Shorten the text to be printed and try again. � Change the tape width setting to OFF and try printing the stamp again. � Delete text from one of the text memory areas and then store the new text. � Replace batteries. � Initialize the Label Printer.
