AEG L62600
Instrukcja Obsługi

Connecting the appliance to the water supply
Important: � This appliance must not be connected to the hot water supply. � When connecting the appliance, use only new hose kits. � Only connect the appliance to the drinking water supply. Rain water or water for industrial use may only be used if it fulfils the requirements of DIN1986 and DIN1988. � Do not kink or crush the water inlet hose or drain hose.

Permitted water pressure
The water pressure must be at least 1 bar (=10N/cm2 =0.1MPa), and may be a maximum of 10bar (=100N/cm2 =1MPa). � If more than 10bar: Connect a pressure reduction valve. � If less than 1bar: Disconnect the appliance end of the inlet hose from the solenoid inlet valve and remove the flow meter. (In addition remove the filter using pointed pliers and take out the rubber gasket behind it.) Replace the filter.

30