|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
5
6
7
8
Note) This product has high voltage circuits inside, and the voltage will be kept for a while by big capacitors. So, before starting disassembly(especially removing the Buss Bars(CND3947)), make sure if the voltage of +VH and -VH become low enough after turning off the power supply(+B & ACC). If you want to discharge the capacitors faster, connect the resistors of same value in parallel with the original discharge resistors (R241 - R246).
A
- Removing the Amp Unit (Fig.3)
1
Remove the eight screws and then remove the four Buss Bars.
2 3 4 5
Remove the two screws. Remove the four screws.
B
Remove the seven screws.
Disconnect the Connector and then remove the Amp Unit.
C
Note) Removal of substrate while the Buss Bar being connected will deform the Buss Bar, failing to set up again. Buss Bar
1
1 5
1 1
1
3
1 4
1 4 4
1
3
3
4 4 4 4
D
3 2
2
Amp Unit
Fig.3 Note) Remove a screw for MODE SELECT only when switching over the mode selection.You do not have to remove this screw when removing the unit board. (Fig.4)
E
Screw for MODE SELECT Fig.4
F
PRS-D2000SPL/XU/UC
5 6 7 8
15
|
