Controls
1. Power on/off and volume control switch 2. Power indicator 3. Tuning LED indicator 4. Dial Scal /pointer 5. Tuning Control 6. Boss for hand strap 7.Telescopic Antenna 8. Earphones jack 9. FM/MW (AM) band selector 10. Battery compartment
Power Supply
To insert the battery, first open the battery cover (10) by sliding it in the direction shown by the arrow. Insert two AA (UM-3) sizes battery into the compartment.
Earphones
Plug the earphones (not supplied )into the earphones jack (8) for private listening. This will disconnect the speaker. Telescopic antenna The Telescopic antenna (7) is for FM band reception. Extend and rotate it for best FM reception. There is a separate directional antenna built into the radio for MW(AM)reception. To achieve the best MW (AM) reception, it may be necessary to rotate the radio. Power and Volume control switch Turn on the power by switching the Power/Volume control switch (1). Adjust it to the desired level of sound. Rotating the control clockwise will increase the sound level. MW/FM band selector (9) Set the band selector to the desired waveband. Tuning Control Slowly rotate the tuning control(5)to select the desired station. Dial Scale/Dial pointer (4) Rotate the tuning control until the dial pointer corresponds to the frequency of the desired station. General maintenance Do not allow this unit to be exposed to water, steam or sand. Do not leave the unit where excessive heat could damage such as in a parked car where the heat from the sun can build up even though the outside temperature may not seem too high. It is recommended that the FM band be used were ever possible as better results in terms of quality and freedom from interference will usually be obtained than on the MW (AW) band. Specifications Battery Frequency coverage Semiconductors Output Power Earphones jack 2 x AA (UM-3)size MW 530 - 1710 kHz FM 87.5 - 108 MHz 1 IC, 1 FET, 1 LED 50 mW 3.5 mm dia (mono)
Design and specifications are subject to change without prior notice.
