JVC DR-M100SEK
Instrukcja Obsługi

TIMER RECORDING

EN

43

Automatic Satellite Programme Recording
This function allows you to automatically record a satellite programme which is timer programmed on your external satellite receiver. Connect a satellite receiver to the unit�s [L-2 IN/ DECODER] connector and programme the timer on the satellite receiver. The unit starts or stops recording by the signals input from the satellite receiver. After recording, the unit�s power shuts off automatically. ATTENTION: � When you record programmes by connecting to a digital terrestrial receiver (Freeview receiver or similar), perform the same steps as AAutomatic Satellite Programme RecordingB (A pg. 43). � Be sure not to turn on the satellite receiver before the programme is executed. Otherwise, the unit will start recording when the satellite receiver�s power is turned on. � If you have connected another appliance other than a satellite receiver to the [L-2 IN/DECODER] connector, be sure not to engage the Automatic Satellite Programme Recording mode. Otherwise, the unit will start recording when the connected appliance�s power is turned on. � Automatic Satellite Programme Recording and timer recording cannot be done at the same time.

� Make sure the satellite receiver is connected to the unit�s [L-2 � Programme the timer on the satellite receiver.

IN/DECODER] connector.

1 2 3

Set AL-2 SELECTB to ASAT VIDEO/RGBB or ASAT S-VIDEO/ RGBB. (A pg. 59) � Also refer to AIMPORTANTB on page 60. Press REC MODE repeatedly to set the recording mode.

Press and hold SATj for about 2 seconds to engage the Automatic Satellite Programme Recording mode. ASAT jB and AVB appear on the front display panel and the unit turns off automatically. NOTES: � To disengage the Automatic Satellite Programme Recording mode, press SATj. � If the unit�s power is off, it is not possible to engage the Automatic Satellite Programme Recording mode. � In step 3, if AVB blinks quickly on the front display panel even though your satellite receiver�s power is off, Automatic Satellite Programme Recording will not work properly with that satellite receiver*. If this is the case, perform AManual Timer ProgrammingB (A pg. 39) to timer record a satellite programme.
* Some satellite receivers output signals even if the power is off. Automatic Satellite Programme Recording is not possible with those satellite receivers. � AVB blinks on the front display panel while Automatic Satellite

Programme Recording is in progress.
� For timer programming of the satellite receiver, refer to the

instruction manual of the satellite receiver.
� Automatic Satellite Programme Recording is not possible if your

satellite receiver does not have a timer.
� Pressing the unit�s A button while Automatic Satellite

SAT j

REC MODE

Programme Recording is in progress turns off the unit�s power and disengages the Automatic Satellite Programme Recording mode. � If there are more than one satellite programmes you wish to record with Automatic Satellite Programme Recording, it is not possible to set different recording modes for each programme. � Depending on the type of satellite receiver, the unit may not record a slight portion of the beginning of the programme or may record slightly longer than the actual length of the programme. � If you engage the Automatic Satellite Programme Recording mode when the satellite receiver�s power is on, the unit will not start Automatic Satellite Programme Recording even though AVB blinks on the front display panel. When the satellite receiver shuts off once and is turned back on again, the unit starts recording. � When the Automatic Satellite Programme Recording mode is engaged, or the unit�s power is turned off after Automatic Satellite Programme Recording is finished, the unit will not enter the timer mode even though AAUTO TIMERB is set to AONB. � Just Clock (A pg. 69) does not work when the Automatic Satellite Programme Recording mode is engaged.